Another Error! D:<
This pops up when I try to run my (WIP) Ruins: Prolouge.
"Brush 12229: FloatPlane: bad normal
Side 0
Texture: METAL/BLACK_WALL_METAL_005A_TOP"
Do I blame it on a leak or...?
(If your curious about Ruins, it's a mixture of the aesthetic themes Overgrown, Reconstructing, Behind the Scenes, and Underground.)
PLEASE DON'T LOOK AT MY POSTS FROM 2013
THEY ARE UGLY AND HIDEOUS
Ok, thanks 
PLEASE DON'T LOOK AT MY POSTS FROM 2013
THEY ARE UGLY AND HIDEOUS
Ok so the map runs now, but the deadly goo vat beneath the chamber doesn't appear.
Is it because the brush beneath it is toolsblack?
PLEASE DON'T LOOK AT MY POSTS FROM 2013
THEY ARE UGLY AND HIDEOUS
No, that's OK with toolsblack. What does your water look like? Did you ONLY texture the top?
No, the bottom is textured too.
I looked and saw that the trigger_hurt and water didn't go all the way down though, so I'll try that.
PLEASE DON'T LOOK AT MY POSTS FROM 2013
THEY ARE UGLY AND HIDEOUS
for water it's the best to make a whole brush nodraw; and then use the texture application tool to texture the top with the water texture!
Ok...
...but then how do I select a single side of a brush?
PLEASE DON'T LOOK AT MY POSTS FROM 2013
THEY ARE UGLY AND HIDEOUS
With the tool that has the picture of a colourful cube. (Did you watch the videos I recommended? Because, I think that in your case, you should watch them before making a mistake again).
Ok. Thanks!
PLEASE DON'T LOOK AT MY POSTS FROM 2013
THEY ARE UGLY AND HIDEOUS